Skip to content
Sunstar Graphics Brochures
  1. Home
  2. Applications
  3. Nameplates and metal labels
Back to Applications

Application · Labels, nameplates and packaging · Plastic and metal parts

Nameplate screen printing machine

Nameplates and metal labels. Nameplates are printed on anodised aluminium, stainless steel and polycarbonate. Plates are rigid, text is small and the print has to resist solvents and abrasion.

See the typical line
What gets printed
  • Machine nameplates and rating plates
  • Control panel plates
  • Metal and polycarbonate labels
Material

Anodised aluminium, stainless steel, polycarbonate

What the job needs
  • Sharp small text
  • Rigid sheet handling
  • Durable, well-cured inks
FAQ

Questions buyers ask

Which machine prints aluminium nameplates?

An electric flatbed such as the ATMA AT-60PPD or AT-80P, which takes rigid sheet up to 25 mm thick.

Also searched as
name plate printing machine, metal label printing machine, aluminium nameplate screen printing, nameplate printing machine, rating plate printing machine, metal printing machine, aluminium label printing machine, logo plate printing

Knowledge

Guides

Useful for this job.

All guides →
Guide

Semi-automatic vs fully automatic screen printing machine

A semi-automatic screen printing machine prints by itself, but an operator loads and removes each sheet. A fully automatic machine also feeds, registers and delivers the sheet to the dryer. Semi-automatic suits short runs and many job changes. Fully automatic suits steady volume, where output and consistency repay the higher cost.

Read →
Guide

Imported vs Indian screen printing machine

A lower-cost Indian-made screen printing machine is a sensible choice for simple graphics, wide tolerances, short runs and a tight budget. A precision imported press earns its cost on multi-layer and functional work, tight register and high volume, where rejects are expensive. The tolerance of your part and the cost of a rejected sheet decide it.

Read →
Guide

Screen printing vs digital printing for industrial parts

Screen printing is the better process for volume production, for thick or opaque ink films and for functional inks such as silver, carbon and glass enamel. Digital printing is better for short runs, many design versions and variable data. It is common to use digital for samples and screen printing for production.

Read →
Guide

Fine-line screen printing on polycarbonate

Fine lines on polycarbonate need four things to be right together: a fine mesh at high tension, a thin and flat stencil with a sharp image, a sharp squeegee at low pressure, and a clean, flat sheet free of static. Lines of around 100 to 150 microns are typically achievable on a well set flatbed press. Finer lines need closer control of every step.

Read →
Guide

Off-contact and snap-off

Off-contact distance, also called snap-off, is the gap between the underside of the screen and the substrate before the squeegee presses the mesh down. On a well-tensioned screen it is typically 1 to 3 mm for small frames and 3 to 8 mm for large frames. Use the smallest gap that lets the mesh lift cleanly behind the squeegee.

Read →
Guide

UV ink not curing

UV ink that stays tacky, scratches off or fails a tape test has usually received too little UV energy for its film thickness and colour. Measure the UV dose on the belt with a radiometer, in mJ/cm², and compare it with the figure in the ink maker's data sheet. The common causes are an aged lamp, dirty reflectors, a belt running too fast and an ink film that is too thick.

Read →

Inquiry

Tell Sunstar what you print.

An engineer replies within one working day with machine options and Indian pricing. Delivered and installed anywhere in India.

0 machines