Skip to content
Sunstar Graphics Brochures

Tool

Squeegee finder

Tap through your job, or start from your industry. Your blade spec updates as you go: hardness, edge, build, angle and length, with the reason behind each choice.

The squeegee finder runs in your browser and needs JavaScript. You can also send the ink, the material, the finest detail, the ink deposit and the press to Sales@sunstargraphics.com, and Sunstar suggests a blade.

Quick start: pick your industry
01

Ink

02

Printing on

03

Finest detail

04

Ink deposit

05

Press

06

Sets blade length
mmWidth of the image, across the stroke.
Refine further Mesh, run length, holders
07

Mesh count

08

Run length

09

Using RKS holders?

Your blade
First print not right?

Fine-tune on press

Edges spread or bleed

Go 5 Shore harder, raise the angle 5°, or re-sharpen the edge.

Patchy cover or pinholes

Go 5 Shore softer or drop the angle 5° to push more ink.

Uneven across the width

Check the blade is straight in its holder. On wide prints use a triple-layer blade.

Blade wears or swells fast

Use a solvent / UV-resistant grade and rotate two blades per shift.

How it decides

The hardness table

Each answer starts from a fixed hardness for your ink and material. Detail, deposit and mesh can then move it by no more than 5 Shore A in total, so the factors never stack up to an extreme.

Ink \ materialSmooth film or sheetRigid flatPaper or cardTextured or unevenFabric / garmentCurved or cylindrical part
UV757575707075
Solvent757570657075
Water-based707570656570
Plastisol707070657070
Conductive paste758075707075
2-pack epoxy757575707075
Glass / ceramic enamel707570707075

Shore A. The highlighted cell is the ink and material chosen in the finder above. The result is held between 60 and 85 Shore A, and the test range is 5 either side.

Squeegee guide

Choosing a squeegee by industry

Membrane switches & overlays

UV or solvent inks on polyester or polycarbonate film. Typically 75–80 Shore A with a sharp square edge for crisp fine text and windows.

Printed electronics & diagnostic strips

Silver and carbon pastes on PET. Typically 75–80 Shore A, sharp square edge, triple-layer blade on automatic lines, and a dedicated squeegee per paste.

PCB

Epoxy legend and solder-mask inks on rigid board. Typically 75 Shore A, square edge, solvent-resistant grade.

PVC cards

UV inks on PVC sheet with fine security detail. Typically 75–80 Shore A, sharp square edge.

Glass & ceramics

Enamels on flat glass or tiles. Typically 70–75 Shore A, square edge, abrasion-resistant grade checked often for wear.

Bottles, tubes & caps

Printed on cylindrical object printers. Typically 75 Shore A with a bevelled or V-point edge for a narrow contact line.

Automotive parts

Solvent or UV inks on rigid plastics and panels. Typically 75 Shore A, square edge.

Textiles & garments

Plastisol or water-based inks on fabric. Typically 65–70 Shore A; a rounded edge for heavy, opaque underbases.

Inquiry

Ask for a blade.

Send the ink, mesh count, material, press model and image size. Sunstar suggests a blade and quotes within one working day.

0 machines